Friday 20 April 2012

DIY macro lens mount and strobe arm

Just for fun I thought I'd make a macro lens mount for my Lumix LX3 in Coolpix housing rig.

Here's what I came up with to hold the Inon UCL-165 M67 onto the dome port.

The 90x75 PVC pipe connector was close to a perfect fit. I stuck some neoprene tabs in the 90mm end to make it a tight fit over the dome port.

I slipped a ring of PVC in the 75mm end to stop the lens pushing all the way through and bolted on small brackets to hold it in place.

For higher magnification it would be better to use a flat port but this macro lens mount means I can do macro and wide on the same dive. A stronger or stacked macro lens would be better because the closest focus on long zoom only came down to 20cm.

I also wanted to reduce the overall size of the setup so replaced the double Ikelite handles with this simple aluminium tray/arm made from 50mm aluminium flat.


No comments:

Post a Comment